Utility Commands
473
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the commands:
(switch) #show sflow receivers 1
Receiver Index................................. 1
Owner String...................................
Time out....................................... 0
IP Address:.................................... 0.0.0.0
Address Type................................... 1
Port........................................... 6343
Datagram Version............................... 5
Maximum Datagram Size.......................... 1400
show sflow samplers
Use this command to display the sFlow sampling instances created on the switch.
Software License Commands
License commands allow you to configure advanced features on some Layer 2 managed
switches. The following table lists the software license matrix for the Layer 2 managed switches.
Note: The software license allows the user to download a license file only on
the Master unit. The file cannot be downloaded on a Slave unit.
There are two options to download the license file to the switch:
• Use the copy c
ommand t
o download the license file through the CLI.
• Go to the Maintenance > Download page to download the licence file through the GUI.
Format show sflow samplers
Mode Privileged EXEC
Field Description
Sampler Data
Sourc
e
The sFlowDataSource (slot/port) for this sFlow sampler. This agent will support Physical
ports only.
Receiver Index The sFlowReceiver configured for this sFlow sampler.
Packet Sampling
Rat
e
The s
tatistical sampling rate for packet sampling from this source.
Max Header Size The maximum number of bytes that should be copied from a sampled packet to form a flow
sample.
Switch IPv4 Routing IPv6 Routing IP Multicast
Managed Switches Licensed Licensed Licensed
To Next Page
Loading...
Need help?
General