NETGEAR ProSAFE M7100-24X - Port Security Commands; Port-Security Max-Dynamic

Security Commands
348
ProSAFE M7100 Managed Switches
Port Security Commands
This section describes the commands you use to configure Port Security on the switch. Port
security, which is also known as port MAC locking, allows you to secure the network by locking
allowable MAC addresses on a port. Packets with a matching source MAC address are forwarded
normally, and all other packets are discarded.
Note: To enable the SNMP trap specific to port security, see snmp-server
enable traps violation on page 544.
port-security
This command enables port locking at the system level (Global Config) or port level (Interface
Config)
.
no port-security
This command disables port locking for one (Interface Config) or all (Global Config) ports.
port-security max-dynamic
This command sets the maximum number of dynamically locked MAC addresses allowed on a
specific port.
Default disabled
Format port-security
Mode • Global Config
• Interface Config
F
ormat no port-security
Mode • Global Config
• Interface Config
Def
ault 600
Format port-security max-dynamic <maxvalue>
Mode Interface Config