Management Commands
555
ProSAFE M7100 Managed Switches
The following shows an example of the command.
(Switch) (Config) #radius server host acct 192.168.37.60
(Switch) (Config) #radius server host acct 192.168.37.60 port 1813
(Switch) (Config) #radius server host auth 192.168.37.60 name Network1_RADIUS_Auth_Server
port 1813
(Switch) (Config) #radius server host acct 192.168.37.60 name Network2_RADIUS_Auth_Server
(Switch) (Config) #no radius server host acct 192.168.37.60
radius server key
Use this command to configure the key to be used in RADIUS client communication with the
specified server. Depending on whether you enter the auth or acct keyword, the shared secret
is configured for the RADIUS authentication or RADIUS accounting server. The IP address or
hostname provided must match a previously configured server. When this command is executed,
the secret is prompted.
Text-based configuration supports Radius server’s secrets in encrypted and non-encrypted
f
ormat
. When you save the configuration, these secret keys are stored in encrypted format only.
If you want to enter the key in encrypted format, enter the key along with the encrypted
keyword. In the show running config command’s display, these secret keys are displayed in
encrypted format. You cannot show these keys in plain text format.
Note: The secret must be an alphanumeric value not exceeding 16 characters.
The following shows an example of the CLI command.
radius server key acct 10.240.4.10 encrypted <encrypt-string>
Format radius server key {auth | acct} {<ipaddr> | <dnsname>} encrypted
<password>
Mode Global Config
Field Description
ipaddr The IP address of the server.
dnsname The DNS name of the server.
password The password in encrypted format.
To Next Page
Loading...
Need help?
General