Switching Commands
33
ProSAFE M7100 Managed Switches
no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is a
number in the range of 0–65535.
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configur
ation that this switch is currently using to the default value.
spanning-tree cost
Use this command to configure the external path cost for a port that is used by an MST instance.
When you use the auto keyword, the path cost from the port to the root bridge is automatically
determined by the speed of the interface. To configure the cost manually, specify a cost value
from 1 to 200000000.
no spanning-tree cost
This command resets the auto-edge status of the port to the default value.
Format no spanning-tree configuration name
Mode Global Config
Default 0
Format spanning-tree configuration revision <0-65535>
Mode Global Config
Format no spanning-tree configuration revision
Mode Global Config
Default auto
Format spanning-tree cost {cost | auto}
Mode Interface Config
Format no spanning-tree auto-edge
Mode Interface Config
To Next Page
Loading...
Need help?
General