NETGEAR ProSAFE M7100-24X - Show Private-Group

Security Commands
290
ProSAFE M7100 Managed Switches
The optional mode for the group can be either isolated or community. If the private group is in
isolated mode, the member port in the group cannot forward its egress traffic to any other
members in the same group. By default, the mode for the private group is community mode,
allowing each member port to forward traffic to other members in the same group, but not to
members in other groups.
no private-group name
This command is used to remove a private group.
show private-group
This command displays information about a private group. If you do not specify a group name,
group identifier, or port, the command displays information about all private groups.
Format private-group name <privategroup-name> [<groupid>] [mode {community |
isolated}]
Mode Global Config
Format no private-group name <privategroup-name>
Mode Global Config
Format show private-group [<private-group-name> | <private-group-id> | port
<unit/slot/port>]
Mode Privileged EXEC
Term Definition
Interface A valid slot and port number separated by forward slashes.
Port VLANID The VLAN ID that is associated with the port.
Private Group ID The identifier of the private group (from 1 to 192).
Private Group
Name
the name of the private group. The name string can be up to 24 bytes of non-blank
char
ac
ters.
Private Group
Mode
The mode of the private group. The mode can be either isolated or community.