Switching Commands
49
ProSAFE M7100 Managed Switches
no vlan
This command deletes an existing VLAN. The ID is a valid VLAN identification number (ID 1 is
reser
ved for the default VLAN). The vlan-list contains VlanId's in range <1-4093>. Separate
non-consecutive IDs with ',' and no spaces and no zeros in between the range; Use '-' for range.
vlan acceptframe
This command sets the frame acceptance mode per interface. For VLAN Only mode, untagged
frames or priority frames received on this interface are discarded. For Admit All mode, untagged
frames or priority frames received on this interface are accepted and assigned the value of the
interface VLAN ID for this port. With either option, VLAN tagged frames are forwarded in
accordance with the IEEE 802.1Q VLAN Specification.
no vlan acceptframe
This command resets the frame acceptance mode for the interface to the default value.
vlan ingressfilter
This command enables ingress filtering. If ingress filtering is disabled, frames received with VLAN
IDs that do not match the VLAN membership of the receiving interface are admitted and
forwarded to ports that are members of that VLAN.
Format no vlan <vlan-list>
Mode VLAN Config
Default all
Format vlan acceptframe {untaggedonly | vlanonly | all}
Mode Interface Config
Format no vlan acceptframe
Mode Interface Config
Default disabled
Format vlan ingressfilter
Mode Interface Config
To Next Page
Loading...
Need help?
General