Routing Commands
180
ProSAFE M7100 Managed Switches
ip default-gateway
Use this command to manually configure a default gateway for the switch. Only one default
gateway can be configured. If you use this command multiple times, each command replaces the
previous value.
no ip default-gateway
Use this command to remove the default gateway address from the configuration.
release dhcp
Use this command to force the DHCPv4 client to release the leased address from the specified
interface.
renew dhcp
Use this command to force the DHCPv4 client to immediately renew an IPv4 address lease on the
specified interface.
Note: This command can be used on in-band ports as well as network
(out-of-band) port.
show dhcp lease
Use this command to display a list of IPv4 addresses currently leased from a DHCP server on a
specific in-band interface or all in-band interfaces. This command does not apply to service or
network ports.
Format ip default-gateway <ipaddr>
Mode Global Config
Format no ip default-gateway <ipaddr>
Mode Interface Config
Format release dhcp <slot/port>
Mode Privileged EXEC
Format renew dhcp {<slot/port> | network-port}
Mode Privileged EXEC
Format show dhcp lease [interface <slot/port>]
Mode Privileged EXEC
To Next Page
Loading...
