Utility Commands
371
ProSAFE M7100 Managed Switches
The following CLI output is an example of the command output.
(Netgear Switch) #show environment
Temp (C)....................................... 30
Temperature traps range: 0 to 90 degrees (Celsius)
Temperature Sensors:
Unit Sensor Description Temp (C) State Max_Temp (C)
---- ------ ---------------- ---------- -------------- --------------
1 1 System 30 Normal 31
Fans:
Unit Fan Description Type Speed Duty level State
---- --- -------------- --------- ------------- ------------- --------------
1 1 System1 Fixed 9200 39 Operational
1 2 System2 Fixed 9200 39 Operational
1 3 Power1 Fixed 9200 39 Operational
1 4 Power2 Fixed 8300 39 Operational
Power supplies:
Unit Power supply Description Type State
---- ------------ ---------------- ---------- --------------
1 1 AC-1 Removable Operational
1 2 AC-2 Removable Not present
show interface
This command displays a summary of statistics for a specific interface or a count of all CPU traffic
based upon the argument.
The display parameters, when the argument is <slot/port> or lag, are as f
ollows:
Format show interface {<slot/port> | switchport | lag <lag-intf-num>}
Mode Privileged EXEC
Parameters Definition
Packets Received
Without Err
or
The total number of packets (including broadcast packets and multicast packets) received by
the processor.
Packets Received
With Err
or
The number of inbound packets that contained errors preventing them from being
deliverable to a higher-layer protocol.
Broadcast
Pack
ets Received
The total number of packets received that were directed to the broadcast address. Note that
this does not include multicast packets.
Packets
Tr
ansmitted
Without Error
The total number of packets transmitted out of the interface.
Transmit Packets
Err
ors
The number of outbound packets that could not be transmitted because of errors.
To Next Page
Loading...
