Switching Commands
130
ProSAFE M7100 Managed Switches
When you specify the <slot/port> value, the following information displays.
When you specify a value for the <vlanid>, the following inf
ormation appears.
show mldsnooping mrouter interface
Use this command to display information about statically configured multicast router attached
interfaces.
show mldsnooping mrouter vlan
Use this command to display information about statically configured multicast router-attached
interfaces.
Term Definition
MLD Snooping
Admin Mode
Indicates whether MLD Snooping is active on the interface.
Fast Leave Mode Indicates whether MLD Snooping Fast Leave is active on the VLAN.
Group
M
embership
Int
erval
Shows the amount of time in seconds that a switch will wait for a report from a particular
group on a particular interface, which is participating in the VLAN, before deleting the
interface from the entry. This value may be configured.
Max Response
T
ime
Display
s the amount of time the switch waits after it sends a query on an interface,
participating in the VLAN, because it did not receive a report for a particular group on that
interface. This value may be configured.
Multicast Router
P
r
esent
Expiration Time
Displays the amount of time to wait before removing an interface that is participating in the
VLAN from the list of interfaces with multicast routers attached. The interface is removed if
a query is not received. This value may be configured.
Term Definition
VLAN Admin
Mode
Indicates whether MLD Snooping is active on the VLAN.
Format show mldsnooping mrouter interface <slot/port>
Mode Privileged EXEC
Term Definition
Interface Shows the interface on which multicast router information is being displayed.
Multicast Router
Att
ached
Indicates whether multicast router is statically enabled on the interface.
VLAN ID Displays the list of VLANs of which the interface is a member.
Format show mldsnooping mrouter vlan <slot/port>
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General