NETGEAR ProSAFE M7100-24X - Peer Detection Enable

Switching Commands
95
ProSAFE M7100 Managed Switches
no peer-keepalive destination
This command removes the IP addresses of the peer MLAG switches.
peer detection enable
This command enables the dual control plane detection protocol (DCPDC) on an MLAG switch.
For the DCPDP to start on an MLAG switch, you first have to configure the IP addresses of the
peer MLAG switches with the peer-keepalive destination command.
no peer detection enable
This command disabled the dual control plane detection protocol (DCPDC) on an MLAG switch.
vpc
This command configures a port channel as part of an MLAG. When you enter this command, the
port channel remains down until the port-channel member information is exchanged and agreed
upon between the MLAG peer switches. You need to enter the ID of the port channel that you
want to configure.
no vpc
This command removes a port channel from an MLAG. You need to enter the ID of the port
channel that you w
ant t
o remove.
Format no peer-keepalive destination <ip-address> source <ip-address>
[udp-port <port>]
Mode VPC Domain Config
Default DCPDC is disabled
Format peer detection enable
Mode VPC Domain Config
Format no peer detection enable
Mode VPC Domain Config
Format vpc <id>
Mode LAG Interface
Format no vpc <id>
Mode LAG Interface