NETGEAR ProSAFE M7100-24X - Show Policy-Map

Quality of Service (QoS) Commands
246
ProSAFE M7100 Managed Switches
show policy-map
This command displays all configuration information for the specified policy. The
<policyname> is the name of an existing DiffServ policy.
If the Policy Name is specified the following fields are displayed:
The following information is repeated for each class associated with this policy (only the policy
attributes that ar
e configured are displayed):
Policy Attribute Table
Size Current /Max
Current number of entries (rows) and the maximum allowed entries (rows) in the
Policy Attribute Table.
Service Table Size
Cur
rent /Max
The current number of entries (rows) i and the maximum allowed entries (rows) in
the Service Table.
Format show policy-map [<policyname>]
Mode Privileged EXEC
Term Definition
Policy Name The name of this policy.
Policy Type The policy type (Only inbound policy definitions are supported for this platform.)
Term Definition
Assign Queue Directs traffic stream to the specified QoS queue. This allows a traffic classifier to specify
which one of the support
ed hardware queues are used for handling packets belonging to the
class.
Class Name The name of this class.
Committed Burst
Siz
e (KB)
The c
ommitted burst size, used in simple policing.
Committed Rate
(Kbps)
The committed rate, used in simple policing,
Conform Action The current setting for the action taken on a packet considered to conform to the policing
par
ame
ters. This is not displayed if policing is not in use for the class under this policy.
Conform COS The CoS mark value if the conform action is set-cos-transmit.
Conform DSCP
V
alue
The DSCP mark v
alue if the conform action is set-dscp-transmit.
Conform IP
Pr
ecedence Value
The IP Precedence mark value if the conform action is set-prec-transmit.
Drop Drop a packet upon arrival. This is useful for emulating access control list operation using
DiffSer
v, especially when DiffServ and ACL cannot co-exist on the same interface.
Term Definition