Security Commands
323
ProSAFE M7100 Managed Switches
no ip arp inspection validate
Use this command to disable the additional validation checks on the received ARP packets.
ip arp inspection vlan logging
Use this command to enable logging of invalid ARP packets on a list of comma-separated VLAN
ranges.
no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated VLAN
ranges.
ip arp inspection trust
Use this command to configure an interface as trusted for Dynamic ARP Inspection.
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface.
Configuring none for the limit means that the interface is not rate limited for Dynamic ARP
Inspections.
Format no ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode Global Config
Default enabled
Format ip arp inspection vlan <vlan-list> logging
Mode Global Config
Format no ip arp inspection vlan <vlan-list> logging
Mode Global Config
Default enabled
Format ip arp inspection trust
Mode Interface Config
Format no ip arp inspection trust
Mode Interface Config
To Next Page
Loading...
