NETGEAR ProSAFE M7100-24X - Show Vpc Brief; Vpc Peer-Link

Switching Commands
96
ProSAFE M7100 Managed Switches
vpc peer-link
This command configures a port channel as the MLAG peer link.
no vpc peer-link
This command removes a port channel as the MLAG peer link.
show vpc brief
This command displays the MLAG global status, including the MLAG operational mode, the peer
link, the keep-alive status, the number of configured and operational MLAGs, and the roles.
The following CLI output is an example of the command output.
(Netgear Switch) #show vpc brief
VPC config Mode................................ Enabled
Keepalive config mode.......................... Enabled
VPC operational Mode........................... Enabled
Self Role...................................... Primary
Peer Role...................................... Secondary
Peer detection................................. Disabled
Peer-Link details
-----------------
Interface...................................... lag 2
Peer link status............................... UP
Peer-link STP Mode............................. Disabled
Configured Vlans............................... 1
Egress tagging................................. none
VPC Details
-----------
Number of VPCs configured...................... 1
Number of VPCs operational..................... 1
VPC id# 1
-----------
Interface...................................... lag 1
Configured Vlans............................... 1
Format vpc peer-link
Mode LAG Interface
Format no vpc peer-link
Mode LAG Interface
Format show vpc brief
Mode Privileged EXEC