Switching Commands
107
ProSAFE M7100 Managed Switches
9 Enabled Disabled --NULL—
10 Enabled Disabled --NULL—
show dhcp l2relay circuit-id vlan
Use this command to display the DHCP circuit ID configuration that is specific to VLANs. For the
<vlan-list> parameter, enter one or more VLAN IDs in the range of 1 to 4093. Use a dash (-) to
specify a range or a comma(,) to separate VLAN IDs in a list. Spaces and zeros are not permitted.
show dhcp l2relay interface
Use this command to display DHCP L2 Relay configuration that is specific to interfaces.
The following CLI output is an example of the command output.
(switch) #show dhcp l2relay interface all
DHCP L2 Relay is Enabled.
Interface L2RelayMode TrustMode
---------- ----------- --------------
0/2 Enabled untrusted
0/4 Disabled trusted
show dhcp l2relay remote-id vlan
Use this command to display the DHCP remote ID that is specific to VLANs. For the <vlan-list>
parameter, enter one or more VLAN IDs in the range of 1 to 4093. Use a dash (-) to specify a
range or a comma(,) to separate VLAN IDs in a list. Spaces and zeros are not permitted.
show dhcp l2relay stats interface
Use this command to display DHCP L2 Relay statistics that are specific to interfaces.
Format show dhcp l2relay circuit-id vlan <vlan-list>
Mode Privileged EXEC
Format show dhcp l2relay interface {all | <interface-num>}
Mode Privileged EXEC
Format show dhcp l2relay remote-id vlan <vlan-list>
Mode Privileged EXEC
Format show dhcp l2relay stats interface {all | <interface-num>}
Mode Privileged EXEC
To Next Page
Loading...
