NETGEAR ProSAFE M7100-24X - MAC Database Commands; Bridge Aging-Time

Switching Commands
155
ProSAFE M7100 Managed Switches
Model Name: xxx xxx xxx
Asset ID: xxx xxx xxx
Location
Subtype: elin
Info: xxx xxx xxx
Extended POE
Device Type: pseDevice
Extended POE PSE
Available: 0.3 Watts
Source: primary
Priority: critical
Extended POE PD
Required: 0.2 Watts
Source: local
Priority: low
MAC Database Commands
This section describes the commands you use to configure and view information about the MAC
databases.
bridge aging-time
This command configures the forwarding database address aging timeout in seconds. The
<seconds> parameter must be within the range of 10 to 1,000,000 seconds.
no bridge aging-time
This command sets the forwarding database address aging timeout to the default value.
Default 300
Format bridge aging-time <10-1,000,000>
Mode Global Config
Format no bridge aging-time
Mode Global Config