NETGEAR ProSAFE M7100-24X - Mvr Type; Mvr Vlan Group; Show Mvr

Multicast VLAN Registration (MVR)
167
ProSAFE M7100 Managed Switches
mvr type
This command sets the MVR port type. When a port is set as source, it is the port to which the
multicast traffic flows using the multicast VLAN. When a port is set to receiver, it is the port
where a listening host is connected to the switch.
no mvr type
Use this command to set the MVR port type to none.
mvr vlan group
Use this command to include the port in the specific MVR group. <mVLAN> is the multicast VLAN,
and <A.B.C.D> is the IP multicast group
no mvr vlan
Use this command to exclude the port from the specific MVR group.
show mvr
This command displays global MVR settings.
The following table explains the output parameters.
Default none
Format mvr type {receiver | source}
Mode Interface Config
Format no mvr type
Mode Interface Config
Format mvr vlan <mVLAN> group <A.B.C.D>
Mode Interface Config
Format no mvr vlan <mVLAN> group <A.B.C.D>
Mode Interface Config
Format show mvr
Mode Privileged EXEC
Term Definition
MVR Running MVR running state. It can be enabled or disabled.
MVR multicast VLAN Current MVR multicast VLAN. It can be in the range from 1 to 4094.