NETGEAR ProSAFE M7100-24X - Ip Dhcp Snooping Database; Ip Dhcp Snooping Binding; Ip Dhcp Snooping Database Write-Delay

Security Commands
330
ProSAFE M7100 Managed Switches
no ip dhcp snooping verify mac-address
Use this command to disable verification of the source MAC address with the client hardware
addres
s.
ip dhcp snooping database
Use this command to configure the persistent location of the DHCP Snooping database. This can
be local or a remote file on a computer.
ip dhcp snooping database write-delay
Use this command to configure the interval in seconds at which the DHCP Snooping database is
persisted. The interval value ranges from 15 to 86,400 seconds.
no ip dhcp snooping database write-delay
Use this command to set the write delay value to the default value.
ip dhcp snooping binding
Use this command to configure static DHCP Snooping binding.
Format no ip dhcp snooping verify mac-address
Mode Global Config
Default local
Format ip dhcp snooping database {local | tftp://hostIP/filename}
Mode Global Config
Default 300 seconds
Format ip dhcp snooping database write-delay <seconds>
Mode Global Config
Format
no ip dhcp snooping database write-delay
Mode Global Config
Format ip dhcp snooping binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode Global Config