NETGEAR ProSAFE M7100-24X - Dos-Control Tcpsyn; Dos-Control Tcpsynfin

Security Commands
358
ProSAFE M7100 Managed Switches
dos-control tcpsyn
This command enables TCP SYN and L4 source = 0-1023 Denial of Service protection. If the
mode is enabled, Denial of Service prevention is active for this type of attack. If packets ingress
having TCP flag SYN set and an L4 source port from 0 to 1023, the packets will be dropped if the
mode is enabled.
no dos-control tcpsyn
This command disables TCP SYN and L4 source = 0-1023 Denial of Service protection.
dos-control tcpsynfin
This command enables TCP SYN and FIN Denial of Service protection. If the mode is enabled,
Denial of Service prevention is active for this type of attack. If packets ingress having TCP flags
SYN and FIN set, the packets will be dropped if the mode is enabled.
no dos-control tcpsynfin
This command disables TCP SYN & FIN Denial of Service protection.
Default disabled
Format dos-control tcpsyn
Mode Global Config
Format no dos-control tcpsyn
Mode Global Config
Default disabled
Format dos-control tcpsynfin
Mode Global Config
Format no dos-control tcpsynfin
Mode Global Config