NETGEAR ProSAFE M7100-24X - Core

Log Messages
591
ProSAFE M7100 Managed Switches
Core
Table 9. BSP Log Messages
Component Message Cause
BSP Event(0xaaaaaaaa) Switch has restarted.
BSP Starting code... BSP initialization complete, starting 7000
series application.
Table 10. NIM Log Messages
Component Message Cause
NIM NIM: L7_ATTACH out of order for
intIfNum(x) unit x slot x por
t x
Interface creation out of order
NIM NIM: Failed to find interface at unit x slot x
port x f
or event(x)
There is no mapping between the USP and
Interface number
NIM NIM: L7_DETACH out of order for
intIfNum(x) unit x slot x por
t x
Interface creation out of order
NIM NIM: L7_DELETE out of order for intIfNum(x)
unit x slot x por
t x
Interface creation out of order
NIM NIM: event(x),intf(x),component(x), in
wrong phase
An ev
ent was issued to NIM during the wrong
configuration phase (probably Phase 1, 2, or
WMU)
NIM NIM: Failed to notify users of interface
change
Event was not propagated to the system
NIM NIM: failed to send message to NIM message
Queue.
NIM message queue full or non-existent
NIM NIM: Failed to notify the components of
L7_CRE
A
TE event
Interface not created
NIM NIM: Attempted event (x), on USP x.x.x
befor
e phase 3
A component issued an interface event
during the wrong initialization phase
NIM NIM: incorrect phase for operation An API call was made during the wrong
initialization phase
NIM NIM: C
omponent(x) failed on event(x) for
intIfNum(x)
A component responded with a fail indication
for an int
erface event
NIM NIM: Timeout event(x), intIfNum(x)
remainingM
ask = “xxxx”
A component did not respond before the NIM
timeout occurred