Security Commands
328
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(Switch) #show ip arp inspection interfaces
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
--------------- ----------- ---------- ---------------
0/1 Untrusted 15 1
0/2 Untrusted 10 10
show arp access-list
Use this command to display the configured ARP ACLs with the rules. Giving an ARP ACL name as
the argument will display only the rules in that ARP ACL.
The following shows example CLI display output for the command.
(Switch) #show arp access-list
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08
Term Definition
Interface The interface ID for each displayed row.
Trust State Whether the interface is trusted or untrusted for DAI.
Rate Limit The configured rate limit value in packets per second.
Burst Interval The configured burst interval value in seconds.
Format show arp access-list [acl-name]
Mode • P
rivileged EXEC
• User EXEC
To Next Page
Loading...
Need help?
General