Switching Commands
77
ProSAFE M7100 Managed Switches
no lacp collector max delay
Use this command to configure the default port-channel collector max delay.
lacp actor admin key
Use this command to configure the administrative value of the LACP actor admin key. The valid
range for <key> is 0-65535.
Note: This command is only applicable to physical interfaces.
no lacp actor admin key
Use this command to configure the default administrative value of the key.
lacp actor admin state individual
Use this command to set LACP actor admin state to individual.
Note: This command is only applicable to physical interfaces.
no lacp actor admin state individual
Use this command to set the LACP actor admin state to aggregation.
Format no lacp collector max-delay
Mode Interface Config
Default Internal Interface Number of this Physical Port
Format lacp actor admin key <key>
Mode Interface Config
Format no lacp actor admin key
Mode Interface Config
Format lacp actor admin state individual
Mode Interface Config
Format no lacp actor admin state individual
Mode Interface Config
To Next Page
Loading...
Need help?
General