Switching Commands
39
ProSAFE M7100 Managed Switches
no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance to the default
value. The par
ameter <mstid> is a number that corresponds to the desired existing multiple
spanning tree instance.
If 0 (defined as the default CIST ID) is passed as the <mstid>, this command se
ts the Bridge
Priority parameter for the Common and Internal Spanning Tree to the default value.
spanning-tree mst vlan
This command adds an association between a multiple spanning tree instance and one or more
VLANs so that the VLAN(s) are no longer associated with the Common and Internal Spanning
Tree. The parameter <mstid> is a number that corresponds to the desired existing multiple
spanning tree instance. The vlan range can be specified as a list or as a range of values. To specify
a list of VLANs, enter a list of VLAN IDs, each separated by a comma with no spaces in between.
To specify a range of VLANs, separate the beginning and ending VLAN ID with a dash ("-").
no spanning-tree mst vlan
This command removes an association between a multiple spanning tree instance and one or
mor
e VL
ANs so that the VLAN(s) are again associated with the Common and Internal Spanning
Tree.
spanning-tree port mode
This command sets the Administrative Switch Port State for this port to enabled.
Format no spanning-tree mst priority <mstid>
Mode Global Config
Format spanning-tree mst vlan <mstid> <vlanid>
Mode Global Config
Format no spanning-tree mst vlan <mstid> <vlanid>
Mode Global Config
Default enabled
Format spanning-tree port mode
Mode Interface Config
To Next Page
Loading...
