Utility Commands
391
ProSAFE M7100 Managed Switches
logging syslog
This command enables syslog logging. The <portid> parameter is an integer with a range of
1-65535.
no logging syslog
This command disables syslog logging.
logging syslog source-interface
This command configures the syslog source-interface.
show logging
This command displays logging configuration information.
Default disabled
Format logging syslog [port <portid>]
Mode Global Config
Format no logging syslog
Mode Global Config
Format logging syslog source-interface {<unit/slot/port> | {loopback
<loopback-id>} | {tunnel <tunnel-id>}}
Mode Global Config
Format show logging
Mode Privileged EXEC
Term Definition
Logging Client
Loc
al Port
The port on the collector/relay to which syslog messages are sent.
CLI Command
Logging
Shows whe
ther CLI Command logging is enabled.
Console Logging Shows whether console logging is enabled.
Console Logging
Sev
erit
y Filter
The minimum severity to log to the console log. Messages with an equal or lower numerical
severity are logged.
Buffered Logging Shows whether buffered logging is enabled.
Syslog Logging Shows whether syslog logging is enabled.
To Next Page
Loading...
