NETGEAR ProSAFE M7100-24X - Show Ip Verify Source; Show Ip Source Binding

Security Commands
337
ProSAFE M7100 Managed Switches
show ip verify source
Use this command to display the IPSG configurations on all ports.
The following shows example CLI display output for the command.
(switch) #show ip verify source
Interface Filter Type IP Address MAC Address Vlan
--------- ----------- --------------- ----------------- -----
0/1 ip-mac 210.1.1.3 00:02:B3:06:60:80 10
0/1 ip-mac 210.1.1.4 00:0F:FE:00:13:04 10
show ip source binding
This command displays the IPSG bindings.
Format show ip verify source
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface The interface address in the slot/port format.
Filter Type One of the following filter types display:
• ip-mac
. Filtering is based on both the IP address and the MAC address.
• ip. Filtering is based on the IP address only.
IP Addr
ess The IP address of the interface.
MAC Address If MAC address filtering is not configured on the interface, the MAC Address field is empty. If
port securit
y is disabled on the interface, then the MAC Address field displays “permit-all.”
VLAN The VLAN for the binding rule.
Format show ip source binding [{static | dynamic}] [interface <slot/port> |
vlan <vlan id>]
Mode • P
rivileged EXEC
• User EXEC
Term Definition
MAC Address The MAC address for the entry that is added.
IP Address The IP address of the entry that is added.
Type Entry type; statically configured from CLI or dynamically learned from DHCP Snooping.
VLAN VLAN for the entry.
Interface IP address of the interface in slot/port format.