NETGEAR ProSAFE M7100-24X - Show Ipv6 Dhcp Snooping Binding; Show Ipv6 Dhcp Snooping Database

Security Commands
343
ProSAFE M7100 Managed Switches
The following CLI output is an example of the command output.
(Netgear Switch) #show ipv6 dhcp snooping
DHCP snooping is Disabled
DHCP snooping source MAC verification is enabled
DHCP snooping is enabled on the following VLANs:
11 - 30, 40
Interface Trusted Log Invalid Pkts
--------- -------- ----------------
0/1 Yes No
0/2 No Yes
0/3 No Yes
0/4 No No
0/6 No No
show ipv6 dhcp snooping binding
This command displays the DHCPv6 snooping binding entries.
The following CLI output is an example of the command output.
(Netgear Switch) #show ipv6 dhcp snooping binding
Total number of bindings: 2
MAC Address IPv6 Address VLAN Interface Lease time(Secs)
------------------ ------------ ---- --------- -------------
00:02:B3:06:60:80 2000::1/64 10 0/1 86400
00:0F:FE:00:13:04 3000::1/64 10 0/1 86400
show ipv6 dhcp snooping database
This command displays the DHCPv6 snooping configuration that is related to the database
persistency.
Format show ipv6 dhcp snooping binding [{static | dynamic}] [interface
<interface-id> | vlan <vlan-id>]
Mode Privileged EXEC
Format show ipv6 dhcp snooping database
Mode Privileged EXEC