EasyManua.ls Logo

NETGEAR ProSAFE M7100-24X - Configuring the Switch Management CPU

NETGEAR ProSAFE M7100-24X
636 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Log Messages
614
ProSAFE M7100 Managed Switches
O/S Support
OS USL: failed to sync initiator table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync terminator table on unit=x Could not synchronize unit x due to a
tr
anspor
t failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync ip-multicast table on unit=
x
Could not synchronize unit x due to a
tr
anspor
t failure or API issue on remote unit.
A synchronization retry will be issued
Table 61. OSAPI Log Messages
Component Message Cause
OSAPI ftruncate failed – File resides on a read-only
file sy
stem.
ftruncate is called to correctly set the file’s
size in the file system after a write. The file
system is R/W so this msg indicates that the
file system may be corrupted.
OSAPI ftruncate failed – File is open for reading
only
.
f
truncate is called to correctly set the files
size in the file system after a write. The file is
opened for R/W so this msg indicates that the
file system may be corrupted.
OSAPI ftruncate failed – File descriptor refers to a
file on which this oper
ation is impos
sible.
ftruncate is called to correctly set the file’s
size in the file system after a write. This msg
indicates that the file system may be
corrupted.
OSAPI ftruncate failed – Returned an unknown code
in er
rno.
f
truncate is called to correctly set the files
size in the file system after a write. This msg
indicates that the file system may be
corrupted.
OSAPI ping: bad host! The address requested to ping cannot be
c
onv
erted to an Internet address.
OSAPI osapiTaskDelete: Failed for (XX) error YYY The requested task cannot be deleted
because: the r
equested deletion is called
from an ISR, the task is already deleted, or
the task ID is invalid.
OSAPI osapiCleanupIf: NetIPGet During the call to remove the interface from
the r
out
e table, the attempt to get an ipv4
interface address from the stack failed.
Table 60. System General Error Messages
Component Message Cause

Table of Contents

Other manuals for NETGEAR ProSAFE M7100-24X

Related product manuals