NETGEAR ProSAFE M7100-24X - Chapter 11 Management Commands

Log Messages
613
ProSAFE M7100 Managed Switches
OS USL: A Trunk being destroyed doesn't exist in
USL
Possible synchronization issue between the
application, hardware, and sync layer.
OS USL: A Trunk being set doesn't exist in USL Possible synchronization issue between the
application, har
dware, and sync layer.
OS USL: failed to sync trunk table on unit=x Could not synchronize unit x due to a
transpor
t failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: Mcast entry not found on a join Possible synchronization issue between the
applic
ation, har
dware, and sync layer
OS USL: Mcast entry not found on a leave Possible synchronization issue between the
application, har
dware, and sync layer
OS USL: failed to sync dvlan data on unit=x Could not synchronize unit x due to a
transpor
t failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync policy table on unit=x Could not synchronize unit x due to a
tr
anspor
t failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync VLAN table on unit=x Could not synchronize unit x due to a
tr
anspor
t failure or API issue on remote unit.
A synchronization retry will be issued
OS Invalid LAG id x Possible synchronization issue between the
BCM driv
er and HAPI
OS Inv
alid uport calculated from the BCM uport
bcmx_l2_addr->lport = x
Upor
t not valid from BCM driver.
OS Invalid USP calculated from the BCM
uport\nbcmx_l2_addr->lpor
t = x
USP not able to be calculated from the learn
event for BCM driver.
OS Unable to insert route R/P Route ‘R’ with prefix ‘P’ could not be inserted
in the hardw
are route table. A retry will be
issued.
OS Unable to Insert host H Host ‘H’ could not be inserted in hardware
hos
t t
able. A retry will be issued.
OS USL: failed to sync L3 Intf table on unit=x Could not synchronize unit x due to a
transpor
t failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync L3 Host table on unit=x Could not synchronize unit x due to a
tr
anspor
t failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync L3 Route table on unit=x Could not synchronize unit x due to a
tr
anspor
t failure or API issue on remote unit.
A synchronization retry will be issued
Table 60. System General Error Messages
Component Message Cause