NETGEAR ProSAFE M7100-24X - Chapter 5 IP Multicast Commands; Multicast Commands

Security Commands
317
ProSAFE M7100 Managed Switches
no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an interface
and disables multicas
t storm recovery.
show storm-control
This command displays switch configuration information. If you do not use any of the optional
parameters, this command displays global storm control configuration parameters:
• Broadcast Storm Control Mode may be enabled or disabled. The factory default is disabled.
• Broadcast Storm Control Level The broadcast storm control level. The factory default is 5%.
• Multicast Storm Control Mode may be enabled or disabled. The factory default is disabled.
• Multicast Storm Control Level The multicast storm control level. The factory default is 5%.
• Unicast Storm Control Mode may be enabled or disabled. The factory default is disabled.
• Unicast Storm Control Level The unicast storm control level. The factory default is 5%.
Use the
all ke
yword to display the per-port configuration parameters for all interfaces, or
specify the slot/port to display information about a specific interface.
Format no storm-control unicast rate
Mode Global Config
Format show storm-control [all | <slot/port>]
Mode Privileged EXEC
Term Definition
Bcast Mode Shows whether the broadcast storm control mode is enabled or disabled. The factory default
is disabled.
Bcast Level The broadcast storm control level.
Mcast Mode Shows whether the multicast storm control mode is enabled or disabled.
Mcast Level The multicast storm control level.
Ucast Mode Shows whether the Unknown Unicast or DLF (Destination Lookup Failure) storm control
mode is enabled or disabled.
Ucast Level The Unknown Unicast or DLF (Destination Lookup Failure) storm control level.