Management Commands
516
ProSAFE M7100 Managed Switches
Access Commands
Use the commands in this section to close remote connections or to view information about
connections to the system.
disconnect
Use the disconnect command to close HTTP, HTTPS, Telnet, or SSH sessions. Use all to close
all active sessions, or use <session-id> to specify the session ID to close. To view the possible
values for <session-id>, use the show loginsession command.
show loginsession
Use this command to display current Telnet and serial port connections to the switch.
Maximum Allowable HTTP
Sessions
The number of allowable unsecure http sessions.
HTTP Session Hard Timeout The hard timeout for unsecure http sessions in hours.
HTTP Session Soft Timeout The soft timeout for unsecure http sessions in minutes.
HTTP Mode (Secure) The secure HTTP server administrative mode.
Secure Port The secure HTTP server port number.
Secure Protocol Level(s) The protocol level might have the values of SSL3, TSL1, or both SSL3 and TSL1.
Maximum Allowable HTTPS
Ses
sions
The number of allow
able secure http sessions.
HTTPS Session Hard Timeout The hard timeout for secure http sessions in hours.
HTTPS Session Soft Timeout The soft timeout for secure http sessions in minutes.
Certificate Present Indicates whether the secure-server certificate files are present on the device.
Certificate Generation in
P
r
ogress
Indicates whether certificate generation is currently in progress.
Format disconnect {<session_id> | all}
Mode Privileged EXEC
Format show loginsession
Mode Privileged EXEC
Term Definition
To Next Page
Loading...
