NETGEAR ProSAFE M7100-24X - Storm-Control Broadcast Rate

Security Commands
309
ProSAFE M7100 Managed Switches
If you select the shutdown keyword and the broadcast traffic increases beyond the threshold,
the interface shuts down instead of dropping packets. To bring up the interface, enter the no
shutdown command for the interface.
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for an interface
and disables broadc
ast storm recovery.
storm-control broadcast rate
Use this command to configure the broadcast storm recovery threshold for an interface in
packets per second. If the mode is enabled, broadcast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for an interface
and disables broadc
ast storm recovery.
Default 5
Format storm-control broadcast level <0-100> [action {ratelimit | shutdown}]
Mode Interface Config
Format no storm-control broadcast level
Mode Interface Config
Default 0
Format storm-control broadcast rate <0-14880000>
Mode Interface Config
Format no storm-control broadcast rate
Mode Interface Config