Utility Commands
486
ProSAFE M7100 Managed Switches
USB commands
If there is a USB flash device in the USB slot, the commands display the device status and content.
show usb device
This command displays USB flash device details.
UDLD Mode The UDLD mode configured on this interface: either Normal or Aggressive.
UDLD Status The status of the link as determined by UDLD. The options are:
• Unde
termined. UDLD has not collected enough information to determine the state of the
por
t.
• No
t applicable. UDLD is disabled, either globally or on the port.
• Shutdown. UDLD has detected a unidirectional link and shut down the port, that is, the
por
t is in an errDisabled state.
• Bidir
ectional. UDLD has detected a bidirectional link.
• Undetermined (Link Down). The port might transition into this state if the port link
phy
sically goes down because of any reason other than the port having been placed into
the D-Disable mode by the UDLD protocol on the switch.
Format show USB device
Mode Privileged EXEC
Parameter Description
Device Status This field specifies the current status of device. Following are possible device status states:
• Ac
tive. Device is plugged in and the device is recognized if device is not mounted.
• Inactive. Device is not mounted.
• Invalid. Device is not present or invalid device is plugged in.
M
anufacturer Manufacturer details.
Serial Number Serial number of the device.
USB Version
C
omplianc
e
Version of the USB device.
Class Code Device Class
Subclass Code Device SubClass
Protocol Device Protocol
Vendor ID Vendor specifies details of device-Vendor ID
Product ID Vendor specifies details of device-Product ID
Term Definition
To Next Page
Loading...
