NETGEAR ProSAFE M7100-24X - Show Ipv6 Dhcp Snooping Interfaces; Clear Ipv6 Dhcp Snooping; Show Ipv6 Verify

Security Commands
345
ProSAFE M7100 Managed Switches
1/0/18 0 0 0
1/0/19 0 0 0
1/0/20 0 0 0
show ipv6 dhcp snooping interfaces
Use this command to show the DHCPv6 snooping status for all interfaces or for a specified
interface.
The following CLI output is an example of the command output for all interfaces.
(Netgear Switch) #show ipv6 dhcp snooping interfaces
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
----------- ---------- ---------- --------------
0/1 No 15 1
0/2 No 15 1
0/3 No 15 1
The following CLI output is an example of the command output for a specific interface.
(Netgear Switch) #show ip dhcp snooping interfaces 1/0/1
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
----------- ---------- ---------- --------------
1/0/1 Yes 15 1
clear ipv6 dhcp snooping
This command clears all DHCPv6 snooping statistics or entries from the DHCPv6 snooping
database.
show ipv6 verify
This command displays the filter types for the IPv6 Source Guard feature for all interfaces or for
a specified interface.
Format show ipv6 dhcp snooping interfaces [interface <interface-id>]
Mode Privileged EXEC
Format clear ipv6 dhcp snooping {statistics | binding [interface
<interface-id>]}
Mode Privileged EXEC
Format show ipv6 verify [interface <unit/slot/port>]
Mode Privileged EXEC