NETGEAR ProSAFE M7100-24X - Exception Core-File; Exception Switch-Chip-Register; Write Core

Utility Commands
491
ProSAFE M7100 Managed Switches
exception core-file
This command configures a prefix for a core dump file name. The maximum prefix length is 15
characters. If you do not specify that the host name must be used in the file name, the MAC
address is used in the file name. You can also configure the time stamp to be added to the file
name.
The file name is
<file-name-prefix>_<hostname>_<time_stamp>.bin
or
<file-name-prefix>_<MAC_address>_<time_stamp>.bin
exception switch-chip-register
This command enables or disables the chip register dump of a switch in case an exception occurs.
The chip register dump is extracted only from a master unit and not for member units.
write core
This command generates a core dump file. The test keyword verifies if the core dump setup is
correct. For example, if you use the exception protocol usb command to configure the protocol
as USB and then enter the write core test command, the file system is mounted and unmounted,
and the CLI output includes the status of the file system. As an option, you can include the
destination file name.
The write core command is also useful when a switch malfunctions, but has not crashed.
Note: When you enter the write core command, the switch reloads.
Default core
Format exception core-file {<file-name-prefix> | [hostname] | [time-stamp]}
Mode Global Config
Default Disable
Format exception switch-chip-register {enable | disable}
Mode Global Config
Format write core [test [<dest_file_name>]]
Mode Privileged EXEC