Management Commands
506
ProSAFE M7100 Managed Switches
show telnetcon
Use this command to display the current inbound Telnet settings. In other words, these settings
apply to Telnet connections initiated from a remote system to the switch.
Secure Shell (SSH) Commands
This section describes the commands you use to configure SSH access to the switch. Use SSH to
access the switch from a remote management host.
Note: The system allows a maximum of five SSH sessions.
ip ssh
Use this command to enable SSH access to the system. (This command is the short form of the ip
ssh server enable command.)
Allow New
Outbound Telnet
Sessions
Indicates whether outbound Telnet sessions will be allowed.
Format show telnetcon
Modes • P
rivileged EXEC
• User EXEC
Term Definition
Remote
Connec
tion Login
Timeout
(minutes)
This object indicates the number of minutes a remote connection session is allowed to remain
inac
tive before being logged off. Might be specified as a number from 1 to 160. The factory
default is 5.
Maximum
Number of
R
emo
te
Connection
Sessions
This object indicates the number of simultaneous remote connection sessions allowed. The
f
actory default is 5.
Allow New Telnet
Sessions
New T
elnet sessions will not be allowed when this field is set to no. The factory default value
is yes.
Default disabled
Format ip ssh
Mode Privileged EXEC
Term Definition
To Next Page
Loading...
