NETGEAR ProSAFE M7100-24X - Show Lldp Med Interface

Switching Commands
149
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(switch) #show lldp med
LLDP MED Global Configuration
Fast Start Repeat Count: 3
Device Class: Network Connectivity
(switch) #
show lldp med interface
Use this command to display a summary of the current LLDP MED configuration for a specific
interface.
<slot/port> indicates a specific physical interface. all indicates all valid LLDP
interfaces.
The following shows example CLI display output for the command.
(Switch) #show lldp med interface all
Interface Link configMED operMED ConfigNotify TLVsTx
--------- ------ --------- -------- ------------ -----------
0/1 Down Disabled Disabled Disabled 0,1
0/2 Up Disabled Disabled Disabled 0,1
0/3 Down Disabled Disabled Disabled 0,1
0/4 Down Disabled Disabled Disabled 0,1
0/5 Down Disabled Disabled Disabled 0,1
0/6 Down Disabled Disabled Disabled 0,1
0/7 Down Disabled Disabled Disabled 0,1
0/8 Down Disabled Disabled Disabled 0,1
0/9 Down Disabled Disabled Disabled 0,1
Format show lldp med interface {<slot/port> | all}
Mode Privileged Exec
Term Definition
Interface The interface in a slot/port format.
Link Shows whether the link is up or down.
ConfigMED Shows if the LLPD-MED mode is enabled or disabled on this interface
OperMED Shows if the LLPD-MED TLVs are transmitted or not on this interface.
ConfigNotify Shows if the LLPD-MED topology notification mode of this interface.
TLVsTx Shows whether the interface sends optional TLVs in the LLDPDUs. The TLV codes can be
0 (C
apabilities), 1 (Ne
twork Policy), 2 (Location), 3 (Extended PSE), 4 (Extended Pd),
or 5 (Inventory).