Switching Commands
81
ProSAFE M7100 Managed Switches
lacp partner admin state passive
Use this command to set the LACP partner admin state to passive.
Note: This command is only applicable to physical interfaces.
no lacp partner admin state passive
Use this command to set the LACP partner admin state to active.
lacp partner port id
Use this command to configure the LACP partner port id. The valid range for <port-id> is
0–65535.
Note: This command is only applicable to physical interfaces.
no lacp partner port id
Use this command to set the LACP partner port id to the default.
Format lacp partner admin state passive
Mode Interface Config
Format no lacp partner admin state passive
Mode Interface Config
Default 0x80
Format lacp partner portid <port-id>
Mode Interface Config
Format no lacp partner portid
Mode Interface Config
To Next Page
Loading...
