NETGEAR ProSAFE M7100-24X - Auto-Voip Protocol-Based; Show Auto-Voip

Quality of Service (QoS) Commands
274
ProSAFE M7100 Managed Switches
no auto-voip oui-based priority
This command is used to set the priority to the default value.
auto-voip protocol-based
This command is used to configure the global protocol-based auto-VoIP remarking
priority/traffic-class. If the remark priority is configured, the voice data of the session is
remarked with the priority configured through this command.
Note: The administrator has to enable tagging on auto-VoIP-enabled ports to
remark the voice data when it is egressed.
no auto-voip protocol-based
This command is used to set the traffic-class to the default value.
show auto-voip
Use this command to display the auto VoIP settings on the interface or interfaces of the switch.
Format no auto-voip oui-based priority <priority-value>
Mode Global Config
Default Traffic-class 7
Format auto-voip protocol-based {remark <remark-priority> | traffic-class
<tc>}
Mode • Global C
onfig
• Interface Config
F
ormat no auto-voip protocol-based {remark <remark-priority> |
traffic-class <tc>}
Mode • Global Config
• Interface Config
F
ormat show auto-voip {protocol-based | oui-based} interface {<slot/port>
| all>}
Mode Privileged EXEC
Field Description
VoIP The global VoIP VLAN ID.
Prioritize Type The type of prioritization used on voice traffic.