Security Commands
324
ProSAFE M7100 Managed Switches
Note: The user interface will accept a rate limit for a trusted interface, but the
limit will not be enforced unless the interface is configured to be
untrusted.
no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default
values of 15 pps and 1 sec
ond, respectively.
ip arp inspection filter
Use this command to configure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges. If the static keyword is given, packets that do not match a
permit statement are dropped without consulting the DHCP snooping bindings.
no ip arp inspection filter
Use this command to unconfigure the ARP ACL used to filter invalid ARP packets on a list of
comma-separ
ated VLAN ranges.
arp access-list
Use this command to create an ARP ACL.
Default 15 pps for rate and 1 second for burst interval
Format ip arp inspection limit {rate <pps> [burst interval <seconds>] |
none}
Mode Interface Config
Format no ip arp inspection limit
Mode Interface Config
Default No ARP ACL is configured on a VLAN
Format ip arp inspection filter <acl-name> vlan <vlan-list> [static]
Mode Global Config
Format no ip arp inspection filter <acl-name> vlan <vlan-list> [static]
Mode Global Config
Format arp access-list <acl-name>
Mode Global Config
To Next Page
Loading...
Need help?
General