Switching Commands
29
ProSAFE M7100 Managed Switches
show interface loopback
This command displays information about configured loopback interfaces.
If you do not specify a loopback ID, the following information appears for each loopback
inter
face on the system:
If you specify a loopback ID, the following information appears:
Format show interface loopback [<loopback-id>]
Mode Privileged EXEC
Term Definition
Loopback ID The loopback ID associated with the rest of the information in the row.
Interface The interface name.
IP Address The IPv4 address of the interface.
Received Packets The number of packets received on this interface.
Sent Packets The number of packets transmitted from this interface.
IPv6 Address The IPv6 address of this interface.
Term Definition
Interface Link
St
atus
Shows whether the link is up or down.
IP Address The IPv4 address of the interface.
IPv6 is enabled
(disabled)
Shows whether IPv6 is enabled on the interface.
IPv6 Prefix is The IPv6 address of the interface.
MTU size The maximum transmission size for packets on this interface, in bytes.
To Next Page
Loading...
