NETGEAR ProSAFE M7100-24X - Show Ip Vrrp; Show Ip Vrrp Interface

Routing Commands
206
ProSAFE M7100 Managed Switches
show ip vrrp
This command displays whether VRRP functionality is enabled or disabled on the switch. It also
displays some global parameters which are required for monitoring. This command takes no
options.
show ip vrrp interface
This command displays all configuration information and VRRP router statistics of a virtual router
configured on a specific interface. Use the output of the command to verify the track interface
and track IP route configurations.
Authentication
Type Mismatch
The total number of VRRP advertisements received for which 'auth type' not equal to locally
configured one for this virtual router.
Packet Length
Err
ors
The total number of VRRP packets received with packet length less than length of VRRP
header.
Format show ip vrrp
Modes • P
rivileged EXEC
• User EXEC
Term Definition
Admin Mode The administrative mode for VRRP functionality on the switch.
Router Checksum
Err
ors
The total number of VRRP packets received with an invalid VRRP checksum value.
Router Version
Err
ors
The total number of VRRP packets received with Unknown or unsupported version number.
Router VRID
Err
ors
The total number of VRRP packets received with invalid VRID for this virtual router.
Format show ip vrrp interface {<interface-name> <vrid>}
Modes • Privileged EXEC
• User EXEC
Term Definition
Primary IP
Addres
s
The configured IP address for the Virtual router.
VMAC address The VMAC address of the specified router.
Authentication
t
ype
The authentic
ation type for the specific virtual router.
Term Definition