Use the Command-Line Interface
16
ProSAFE M7100 Managed Switches
In other words, to execute a command that is normally supported only in Privileged EXEC mode,
you do not need to switch to Privileged EXEC mode as long as you place the do command before
the command that is normally supported only in Privileged EXEC mode.
show
This command lets you execute a show command that is normally supported only in Privileged
EXEC mode, Global Config mode, Interface Config mode, VLAN config mode, or Routing Config
mode, in any other of these five modes.
For example, to execute a show command that is normally supported only in Interface Config
mode, you do not need t
o switch to Interface Config mode as long as you place the show
command before the show command that is normally supported only in Interface Config mode.
Command Completion and Abbreviation
Command completion finishes spelling the command when you type enough letters of a
command to uniquely identify the command keyword. Once you have entered enough letters,
press the SPACEBAR or TAB key to complete the word.
Command abbreviation allows you to execute a command when you have entered there are
enough lett
ers to uniquely identify the command. You must enter all of the required keywords
and parameters before you enter the command.
Format do <command in Privileged EXEC mode>
Mode Privileged EXEC
Global Config
Interface Config
VLAN Config
Routing Config
Format show <show command from any other config mode>
Mode Privileged EXEC
Global Config
Interface Config
VLAN Config
Routing Config
To Next Page
Loading...
Need help?
General