Security Commands
342
ProSAFE M7100 Managed Switches
ipv6 verify source
This command lets DHCPv6 snooping use the source ID attribute to verify and filter data traffic in
the hardware. The source ID attribute is a combination of the IPv6 address and the MAC address.
Enable the port-security option to allow filtration of data traffic based on IPv6 and MAC
addresses.
no ipv6 verify source
This command prevents DHCPv6 snooping from using the source ID attribute to verify and filter
data tr
affic in the hardware.
ipv6 verify binding
This command configures a static entry for the IPv6 Source Guard feature.
no ipv6 verify binding
This command removes a static entry for the IPv6 Source Guard feature.
show ipv6 dhcp snooping
This command displays global configurations and per-port configurations for DHCPv6 snooping.
Default IPv6 address
Format ipv6 verify source [port-security]
Mode Interface config
Format no ipv6 verify source
Mode Interface config
Format ipv6 verify binding <mac-address> vlan <vlan-id> <ipv6 address>
interface <interface-id>
Mode Global config
Format no ipv6 verify binding <mac-address> vlan <vlan-id> <ipv6 address>
interface <interface-id>
Mode Global config
Format show ipv6 dhcp snooping
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General