Management Commands
538
ProSAFE M7100 Managed Switches
The domain can be enabled or disabled:
• Domain enabled. In this case, when the user ent
ers only the user name, then the managed
switch sends the user name as the domain name (configured on switch)\username to the
RADIUS server. If the user enters the domain name and user name, the managed switch sends
the user name input as the domain name (as entered by the user)\username to the RADIUS
server.
• Domain disabled. In this c
ase, the domain name is no
t included when the user name is sent to
the RADIUS server.
Note: If the user domain is already provided by the user or supplicant, the
domain name is assumed to reach the managed switch along with the
user name in the following format: "Domainname \username"
no domain-name
This command is used to disable the domain-name in the managed switch.
domain-name enable
This command enables the domain name functionality.
no domain-name enable
This command disables the domain name functionality.
Format domain-name <name>
Mode Global Config
Format no domain-name
Mode Global Config
Format domain-name enable
Mode Global Config
Format no domain-name enable
Mode Global Config
To Next Page
Loading...
Need help?
General