NETGEAR ProSAFE M7100-24X - Ip Dhcp Conflict Logging; Clear Ip Dhcp Binding; Clear Ip Dhcp Server Statistics; Clear Ip Dhcp Conflict

Utility Commands
431
ProSAFE M7100 Managed Switches
ip dhcp conflict logging
This command enables conflict logging on DHCP server.
no ip dhcp conflict logging
This command disables conflict logging on DHCP server.
clear ip dhcp binding
This command deletes an automatic address binding from the DHCP server database. If “*” is
specified, the bindings corresponding to all the addresses are deleted. <address> is a valid IP
address made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
clear ip dhcp server statistics
This command clears DHCP server statistics counters.
clear ip dhcp conflict
The command is used to clear an address conflict from the DHCP Server database. The server
detects conflicts using a ping. DHCP server clears all conflicts If the asterisk (*) character is used
as the address parameter.
Default enabled
Format ip dhcp conflict logging
Mode Global Config
Format
no ip dhcp conflict logging
Mode Global Config
Format clear ip dhcp binding {<address> | *}
Mode Privileged EXEC
Format clear ip dhcp server statistics
Mode Privileged EXEC
Default none
Format clear ip dhcp conflict {<address> | *}
Mode Privileged EXEC