NETGEAR ProSAFE M7100-24X - Vlan Pvid; Protocol Vlan Group All

Switching Commands
56
ProSAFE M7100 Managed Switches
no protocol vlan group
This command removes the interface from this pr
otocol-based VLAN group that is identified by
this <groupid>.
protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by <groupid>.
You can associate multiple interfaces with a group, but you can only associate each interface and
protocol combination with one group. If adding an interface to a group causes any conflicts with
protocols currently associated with the group, this command will fail and the interface(s) will not
be added to the group.
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified by
this <groupid>.
vlan pvid
This command changes the VLAN ID per interface.
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format no protocol vlan group <groupid>
Mode Interface Config
Default none
Format protocol vlan group all <groupid>
Mode Global Config
Format no protocol vlan group all <groupid>
Mode Global Config
Default 1
Format vlan pvid <1-4093>
Mode Interface Config
Format no vlan pvid
Mode Interface Config