Switching Commands
148
ProSAFE M7100 Managed Switches
lldp med transmit-tlv all
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set will
be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
no lldp med transmit-tlv
Use this command to remove a TLV.
show lldp med
Use this command to display a summary of the current LLDP MED configuration.
Default By default, the capabilities and network policy TLVs are included.
Format lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse]
[inventory] [location] [network-policy]
Mode Global Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
inventory Transmit the LLDP inventory TLV.
location Transmit the LLDP location TLV.
network-policy Transmit the LLDP network policy TLV.
Format no lldp med transmit-tlv all [capabilities] [network-policy]
[ex-pse] [ex-pd] [location] [inventory]
Mode Global Config
Format show lldp med
Mode Privileged Exec
Term Definition
Fast Start Repeat
Count
The number of LLDP PDUs that will be tr
ansmitted when the protocol is enabled.
Device Class The local device’s MED Classification. There are four different kinds of devices, three of
which repr
esent the actual endpoints, that are classified as Class I Generic [for example, an IP
communication controller], Class II Media (for example, a conference bridge], Class III
Communication [for example, an IP telephone], and Class IV Network Connectivity Device,
which is typically a LAN switch, router, or IEEE 802.11 wireless access point.
To Next Page
Loading...
Need help?
General