NETGEAR ProSAFE M7100-24X - Ip Route Default; Ip Route Distance

Routing Commands
182
ProSAFE M7100 Managed Switches
no ip route
This command deletes a single next hop to a destination static route. If you use the
<nexthopip> parame
ter, the next hop is deleted. If you use the <preference> value, the
preference value of the static route is reset to its default.
ip route default
This command configures the default route. The value for <nexthopip> is a valid IP address of
the next hop router. The <preference> is an integer value from 1 to 255. A route with a
preference of 255 cannot be used to forward traffic.
no ip route default
This command deletes all configured default routes. If the optional <nexthopip> parame
ter is
designated, the specific next hop is deleted from the configured default route and if the optional
preference value is designated, the preference of the configured default route is reset to its
default.
ip route distance
This command sets the default distance (preference) for static routes. Lower route distance
values are preferred when determining the best route. The ip route and ip route
default commands allow you to optionally set the distance (preference) of an individual static
route. The default distance is used when no distance is specified in these commands. Changing
the default distance does not update the distance of existing static routes, even if they were
assigned the original default distance. The new default distance will only be applied to static
routes created after invoking the ip route distance command.
Format no ip route <ipaddr> <subnetmask> [<nexthopip> | Null0]
[<preference>]
Mode Global Config
Default preference—1
Format ip route default <nexthopip> [<preference>]
Mode Global Config
Format ip route default [<nexthopip>] [<preference>]
Mode Global Config
Default 1
Format ip route distance <1-255>
Mode Global Config