NETGEAR ProSAFE M7100-24X - Match Ethertype; Match any; Match Class-Map

Quality of Service (QoS) Commands
230
ProSAFE M7100 Managed Switches
match ethertype
This command adds to the specified class definition a match condition based on the value of the
ethertype. The <ethertype> value is specified as one of the following keywords: appletalk,
arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe,
rarp or as a custom ethertype value in the range of 0x0600-0xFFFF.
match any
This command adds to the specified class definition a match condition whereby all packets are
considered to belong to the class.
match class-map
This command adds to the specified class definition the set of match conditions defined for
another class. The <refclassname> is the name of an existing DiffServ class whose match
conditions are being referenced by the specified class definition.
Note the following:
• The parameters <
refclassname> and <class-map-name> cannot be the same.
• Only one other clas
s might be referenced by a class.
• Any attempts to delete the <refclassname> class while the class is still referenced by any
<
class-map-name> fails.
• The combined match criteria of <class-map-name> and <
refclassname> must be an
allowed combination based on the class type.
• Any subsequent changes to the <
refclassname> class match criteria must maintain this
validity, or the change attempt fails.
• The total number of class rules formed by the complete reference class chain (including both
pr
edecessor and successor classes) must not exceed a platform-specific maximum. In some
Format match ethertype {<keyword> | custom <0x0600-0xFFFF>}
Mode • Class-Map Config
• Ipv6-Class-M
ap Config
Default none
Format match any
Mode • Clas
s-Map Config
• Ipv6-Class-Map Config
Default none
Format match class-map <refclassname>
Mode • Class-Map Config
• Ipv6-Class-M
ap Config