Switching Commands
125
ProSAFE M7100 Managed Switches
no set mld
Use this command to disable MLD Snooping on the system.
set mld interfacemode
Use this command to enable MLD Snooping on all interfaces. If an interface has MLD Snooping
enabled and you enable this interface for routing or enlist it as a member of a port-channel
(LAG), MLD Snooping functionality is disabled on that interface. MLD Snooping functionality is
re-enabled if you disable routing or remove port-channel (LAG) membership from an interface
that has MLD Snooping enabled.
no set mld interfacemode
Use this command to disable MLD Snooping on all interfaces.
set mld fast-leave
Use this command to enable MLD Snooping fast-leave admin mode on a selected interface or
VLAN. Enabling fast-leave allows the switch to immediately remove the Layer 2 LAN interface
from its forwarding table entry upon receiving and MLD done message for that multicast group
without first sending out MAC-based general queries to the interface.
Default disabled
Format set mld <vlanid>
Mode • Global Config
• Interface Config
• VLAN Mode
F
ormat no set mld <vlanid>
Mode • Global Config
• Interface Config
• VLAN Mode
Def
ault disabled
Format set mld interfacemode
Mode Global Config
Format no set mld interfacemode
Mode Global Config
To Next Page
Loading...
Need help?
General