NETGEAR ProSAFE M7100-24X Reference Manual

Management Commands
553
ProSAFE M7100 Managed Switches
radius server attribute 4
Use this command to specify the RADIUS client to use the NAS-IP Address attribute 4 in the
RADIUS requests. If the specific IP address is configured while enabling this attribute, the RADIUS
client uses that IP address while sending NAS-IP-Address attribute 4 in RADIUS communication.
no radius server attribute 4
Use this command to disable the NAS-IP-Address attribute 4 global parameter for RADIUS
clients. When this par
ame
ter is disabled, the RADIUS client does not send the NAS-IP-Address
attribute 4 in RADIUS requests.
The following shows an example of the command.
(Switch) (Config) #radius server attribute 4 192.168.37.60
(Switch) (Config) #radius server attribute 4
radius server host
Use this command to configure the IP address or DNS name to use for communicating with the
RADIUS server of a selected server type. While configuring the IP address or DNS name for the
authenticating or accounting servers, you can also configure the port number and server name. If
the authenticating and accounting servers are configured without a name, the command uses the
‘Default_RADIUS_Auth_Server’ and ‘Default_RADIUS_Acct_Server’ as the default names,
respectively. The same name can be configured for more than one authenticating servers and the
name should be unique for accounting servers. The RADIUS client allows the configuration of a
maximum 32 authenticating and accounting servers.
If you use the <auth> par
ame
ter, the command configures the IP address or hostname to use to
connect to a RADIUS authentication server. You can configure up to 3 servers per RADIUS client.
If the maximum number of configured servers is reached, the command fails until you remove
one of the servers by issuing the “no” form of the command. If you use the optional <port>
parameter, the command configures the UDP port number to use when connecting to the
configured RADIUS server. The number range for the <port> parameter is 1 - 65535, with
1812 as default value.
Format radius server attribute 4 <ipaddr>
Mode Global Config
Term Definition
4 NAS-IP-Address attribute to be used in RADIUS requests.
ipaddr The IP address of the server.
Format no radius server attribute 4 <ipaddr>
Mode Global Config

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English